Here You Go, Bob - Photos of Ebony Tip on Forend

[durco]

Excuse the poor photo quality, as this is my first attempt at posting a photo. Anyway, here are a couple of shots of the ebony tip on my SKEET grade gun, #26126.

Photo #1:

http://i877.photobucket.com/albums/ab335/mdurhan/DSCN0671.jpg

And, photo #2:

http://i877.photobucket.com/albums/ab335/mdurhan/DSCN0672.jpg

Hope this worked.....
Mike Durhan

[rperlichek]

Mike: Thanks for posting the photos. I see that there is a slight radius on the narrow end of the insert (toward the back). Any chance you can estimate the radius and at the same time measure the width at the front and the overall length ?

Thanks -- Bob

[durco]

Bob:

I'm going to refer to the shape of the insert as a "funnel".
The two top corners are sharp - not radiused.
The top edge is 3/4" wide and very slightly convex in shape.
The length is 1-1/2".
The width gradually tapers down to 1/8" at bottom.
Therefore, mathmatically, the bottom radius is 1/16".

Hope this helps.
Mike